Compatibility

What you need

3DPrintSaver.com works with FDM printers controlled through OctoPrint or Klipper with Moonraker.

Printer brand alone is not enough. The software that controls your printer matters.

Check your setup

OctoPrintUse this if OctoPrint normally runs your printer.

Klipper with MoonrakerUse this if you normally print through Fluidd or Mainsail.

Network accessYour device must reach the printer when you want upload or motion controls.

If you print through OctoPrint, Fluidd, or Mainsail, you are probably close.

If you only print from an SD card, 3DPrintSaver.com may still make a recovery file. Guided printer controls are not the normal supported path.

Printer connections stay on your local network. 3DPrintSaver.com uses only the limited activation and service data described in the Privacy Policy.

When in doubt, email [email protected] with your printer, firmware, and printer app before buying.