Guided failed-print recovery

Can I save this print?

Keep the original G-code and measure the part that already printed. Recovery depends on the printer, the condition of the part, and whether it can be aligned safely.

This page does not inspect your file. Open the Agent to review your file, choose the failure height, and follow the checks for your printer.

Get the free Agent

The feature that started it all

A failed print does not have to mean starting over.

Keep the hours you already printed. 3DPrintSaver uses the original G-code and your measured failure height to rebuild the remaining print, then guides you through alignment and resuming from the layer of failure.

Recovery lives inside the same workspace as your models, slicer, and printers. You can inspect the recovery plan before sending it to your printer.

  1. Choose the original file. Start with the G-code used for the failed print.
  2. Find the failure layer. Measure the printed part and review where to resume.
  3. Prepare and align. Follow the guided checks for your printer and partial print.
  4. Resume printing. Once aligned, start the remaining job.

One app. Your slicer. Your printers.

Klipper / Moonraker

Connect to Moonraker for printer status, supported controls, cameras, file transfers, and guided recovery.

OctoPrint

Connect the Agent to your existing OctoPrint server. Status, cameras, controls, and recovery depend on the server and printer configuration.

Bambu Lab LAN

Connect supported Bambu Lab printers on your local network with LAN-only and Developer Mode configured where required.

Connect an installed OrcaSlicer for slicing. The Agent brings model preparation, slicing, printer connections, monitoring, and recovery into one workspace; OrcaSlicer is installed separately.

Capabilities vary by printer and interface. The Agent's guided failed-print recovery is not currently supported for Bambu printers. Other recovery paths may support a moved or detached part with guided alignment; a successful recovery is never guaranteed.